-
Comparison between Ender Nail and Interlocking Nail in The Treatment of Infra-isthmic Tibial Shaft Fracture
-
Seung Wook Yang, Moo Ho Song, Hyung Taek Park, Sun Jin Choi
-
J Korean Soc Fract 2001;14(4):651-659. Published online October 31, 2001
-
DOI: https://doi.org/10.12671/jksf.2001.14.4.651
-
-
 Abstract
 PDF
- PURPOSE
To compare the clinical results between Ender nail and interlocking nail in the treatment of infra-isthmic tibial shaft fracture.
MATERIALS AND METHODS
The authors analyzed 44 cases of infra-isthmic tibial shaft fracture treated with Ender nail(23 cases) as a group 1 or interlocking nail(21 cases) as a group 2 from 1994 to 1998. Fracture type was divided by AO classification, and measured the fracture level, the time of bone union and angular deformity was checked with roentgenograms. The functional results were compared using the criteria by Klemm and Borner.
RESULTS
Distal end of fracture line from ankle joint shows no difference between two groups(P>0.05). Mean operation time was 96 minutes in group 1 and 140 minutes in group 2(P<0.05). Mean intraoperative blood loss was 103cc in group 1 and 254cc in group 2(P<0.05). Mean bone union time was 19.26 weeks in group 1 and 24.81 weeks in group 2. There was no significant difference between two groups in the angulation(P>0.05) and the functional results by Klemm and Borner.
CONCLUSION
Ender nail is a good method of treatment in infra-isthmic tibial fracture when isthmic portion of tibia is too narrow, or insertion of distal interlocking screws were too difficult to insert because of the severe soft tissue injury. The stability of fixation can be strengthened with a three point fixation as fanning of the nails in the distal fragments using more than 3 nails selecting a 1cm longer nail than the ordinary nail length for diaphyseal fracture.
-
Malalignment of Tibial Fracture Following Interlocking Intramedullary Nailing
-
Seung Wook Yang, Hyung Taek Park, Kuen Tak Suh
-
J Korean Soc Fract 2000;13(2):236-243. Published online April 30, 2000
-
DOI: https://doi.org/10.12671/jksf.2000.13.2.236
-
-
Abstract
PDF
- PURPOSE
: The purpose of this study was to evaluate the incidence and the factors that influence on malalignment following interlocking nailing for tibial fracture.
MATERIALS AND METHODS
: The authors analysed 59 patients, 60 cases tibial fracture treated with interlocking intramedullary nailing from 1993 to 1997 about nail insertion site, nail entrance angle and fracture type with roentegenogram. Malalignment was defined as 5 degree or more angular deformity in varus-valgus, 10 degree or more angular deformity in anterior-posterior plane.
RESULTS
: Malalignment was found in 15 cases out of 60(25%). We found malalaignment in 7 cases out of 11(64%)in proximal fracture, 6 cases out of 29(21%) in middle fracture, 2 cases out of 20(10%) in distal fracture(p<0.001). Correlation between nail insertion site or medial entrance angle and angular deformity was higher in proximal fractures. In midshaft wedge fractures, direction of main fragment influenced on the axial alignment.
CONCLUSION
: Centromedullary nail orientation is required to prevent malalignment after interlocking intramedullary nailing. Precise selection of nail insertion site and nail entrance angle under the C-arm control in proximal tibial fracture is necessary. Fracture type and fragment direction must be considered during tibial nailing in comminuted tibial fracture.
|
E-submission
KFS
